Morris 63 to 74 check your distributor number

Add to cart
  • Description
  • More
  • Specifications

Upgrade your Classic Morris Ignition system to a Pertronix Ignitor Electronic Kit, easily fitted, discreetly under cap, once fitted never change points again. Fits Lotus Morris cars from 1963 to 1974

Get even more out of your Ignitor Purchase, Upgrade to one of Flame Thrower Coils

40,000 and 45,000 volts


Operating Voltage: 8-V to 16-V DC

Temperature Range: -50 to 300F

RPM Range: 0 to 15,000 RPM

Can be used with most point-type coils, optimal performance achieved when used with our Flame-Thrower® 40,000 volt coil.

Works great in stock point-type distributors as a trigger for multi-spark CD ignitions, eliminating the need for expensive aftermarket distributors.

No complicated wiring makes installation easy.

A solid-state electronic ignition system. "Never change points again!"


The Ignitor II has many of the same great feature that the Ignitor has, but its smarter. Ignitor II units sense the coil current level and use a powerful micro controller to adjust the dwell. Variable dwell helps to maintain peak energy throughout the entire RPM range.


Ignitor II systems develop up to 4 times more energy between 3000 and 5000 RPM than standard ignition systems. High RPM performance is improved when used with the Flame-Thrower II super low resistance (0.6 ohms) 45,000 volt coil.

Adaptive dwell maintains peak energy throughout the entire RPM range, reducing misfires while improving engine performance.

Develops on average 4 times more available energy between 3000 and 5000 RPM, and 2 times more available plug voltage.

Peak current level is reached just prior to spark for maximum energy without the heat build-up, increasing coil and module life.

Adjusts spark timing at higher RPMs to compensate for the inherent electronic delay.

Senses start up and develops more energy for quicker, easier starting. Built in reverse polarity and over current protection shuts down the system, preventing component damage.


Brand: PerTronix

Part Number: LU142A, LU-142AP12, 9LU-142A

Part Type: Electronic Ignition Kits

Product: PerTronix Ignitor® Solid-State Ignition Systems

Trigger Style: Hall effect

Ground: 12 volt neg, 12 volt pos, 6 volt pos


Advance Type: Vacuum and mechanical

Quantity: Sold as a kit


Please Check Footnotes 79 below before ordering


Special Foot Notes Please Read

2             Factory electronic ignition

4             Non fuel injection models

6             California models only

7             Manual trans only

9             Excluding California model with auto trans

10            Dual point distributor

13            Lobe sensor module

14            European models only

16            Mechanical advance under breaker plate

17            Small cap distributor

19            Mechanical advance at top of shaft

20            Large cap distributor

22            Clockwise rotation

24            Counter clockwise rotation

33            Vacuum advance distributor

34            Non vacuum advance distributor

36            Excluding distributor number 1112314

38            Excluding distributor number IDN-4007

39            With “curved” point set

40            With “straight” point set

43            Odd fire engine

55            Also available in 6-volt negative ground add N6                to part number

56            Also available in 6-volt positive ground, add P6                to part number

57            Also available in 12-volt positive ground, add                P12 to part number

59            Single distributor applications

60            Dual distributor applications

61            Kit contains one module for each distributor

63            With four lobe point cam

64            With three lobe point cam

70            Early DM2 distributor with two piece point set

72            Fits both single point and dual point distributors

79            Ignitor II applications cannot be used with solid                core ignition wires

83            With plastic sliding point plate

85            Point cam felt bracket removal required

86            Requires modification to distributor

88            Ignitor III kit available see page 4 for details

95            2 bolt front mount distributor

96            With factory Holley gold box ignition

Related Products