Pontiac 55 to 56 - 8 cylinder - Delco advance under breaker plate

Pertronix
1183
694342012861
kg
Add to cart
  • Description
  • More
  • Specifications

Upgrade your Classic Pontiac Ignition system to a Pertronix Ignitor Electronic Kit, easily fitted, discreetly under cap, once fitted never change points again. Fits Pontiac 8 cylinder cars from 1955 to 1956 Delco distributor.

Also available in 12 volt pos, 6 volt neg and 6 volt pos ground

Get even more out of your Ignitor Purchase, Upgrade to one of Flame Thrower Coils

40,000 and 45,000 volts

 

Features

Operating Voltage: 8-V to 16-V DC

Temperature Range: -50 to 300F

RPM Range: 0 to 15,000 RPM

Can be used with most point-type coils, optimal performance achieved when used with our Flame-Thrower® 40,000 volt coil.

Works great in stock point-type distributors as a trigger for multi-spark CD ignitions, eliminating the need for expensive aftermarket distributors.

No complicated wiring makes installation easy.

A solid-state electronic ignition system. "Never change points again!"

                   

The Ignitor II has many of the same great feature that the Ignitor has, but its smarter. Ignitor II units sense the coil current level and use a powerful micro controller to adjust the dwell. Variable dwell helps to maintain peak energy throughout the entire RPM range.

Features

Ignitor II systems develop up to 4 times more energy between 3000 and 5000 RPM than standard ignition systems. High RPM performance is improved when used with the Flame-Thrower II super low resistance (0.6 ohms) 45,000 volt coil.

Adaptive dwell maintains peak energy throughout the entire RPM range, reducing misfires while improving engine performance.

Develops on average 4 times more available energy between 3000 and 5000 RPM, and 2 times more available plug voltage.

Peak current level is reached just prior to spark for maximum energy without the heat build-up, increasing coil and module life.

Adjusts spark timing at higher RPMs to compensate for the inherent electronic delay.

Senses start up and develops more energy for quicker, easier starting. Built in reverse polarity and over current protection shuts down the system, preventing component damage.

Tech

Brand: PerTronix Ignitor I and II

Part Number: 1183, 1183P6, 1183N6, 1183P12, 91183

Part Type: Electronic Ignition Kits

Product: PerTronix Ignitor® Solid-State Ignition Systems

Trigger Style: Hall effect

Ground: 12 volt neg, 6 volt neg, 12 volt pos, 6 volt pos

Distributor: DELCO EARLY 8 CYL mechanical advance under breaker plate

Quantity: Sold as a kit.

 

Please Check Footnotes, 16, 55, 79 below before ordering

 

Special Foot Notes please read

1             Excluding California models

2             Factory electronic ignition

8             Single point distributor

10            Dual point distributor

13            Lobe sensor module

16            Mechanical advance under breaker plate

18            Excluding 215 and 300 cid. engine

19            Mechanical advance at top of shaft

33            Vacuum advance distributor

34            Non vacuum advance distributor

36            Excluding distributor number 1112314

40            With “straight” point set

55            Also available in 6-volt negative ground add N6                to part number

56            Also available in 6-volt positive ground, add P6                to part number

57            Also available in 12-volt positive ground, add                P12 to part number

63            With four lobe point cam

64            With three lobe point cam

70            Early DM2 distributor with two piece point set

71            Late DM2 distributor with one piece point set

72            Fits both single point and dual point distributors

79            Ignitor II applications cannot be used with solid                core ignition wires

86            Requires modification to distributor

88            Ignitor III kit available see page 4 for details

Related Products